Argo AES Series Manuál s instrukcemi Strana 117

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 262
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 116
117
A
-Modell - 11/12 - Ausgabe 09/11 - 2096161 - BUE-0036-10EN
Electrical system
8
The main menu can be accessed with the menu key (Fig. 121,7):
z Operating mode
z Fuel cartridge
z System information
z Language
z System reset
In the event of faults, the red fault indicator (Fig. 121,5) lights up and a mes-
sage appears on the display. The message consists of an error code and infor-
mation on how to rectify the fault.
After rectifying the fault, carry out a system reset.
If the tank cartridge needs to be changed or service fluid replenished, this will
also be indicated.
Switching on:
Press the On/Off key.
Select the desired operating mode and confirm with "OK".
Switching off:
Press the On/Off key.
Select the "Manual Off" operating mode and confirm with "OK". The fuel
cell switches itself off in a controlled way. This procedure can take a while.
"Shutdown procedure" appears on the display.
Automatic mode Automatic mode starts as soon as the device is attached to the power supply.
The device monitors the battery voltage independently.
The fuel cell switches itself on automatically when the battery voltage falls
below 12.3 Volts. The battery is then charged to reach the switch-off threshold
(14.2 Volts).
When started, the device runs through a start phase lasting up to 20 minutes.
Only after this period is its full nominal power reached.
Battery protection This function prevents the battery from discharging completely when the oper-
ating mode is set to "Off".
Battery protection is activated automatically when the battery voltage falls
below 11.2 Volts for more than 15 minutes. The "Battery protection" charge
mode ends when the voltage of 12.8 Volts is reached.
Frost protection This mode is triggered automatically as soon as the temperature falls below
3 °C. It prevents the device from freezing.
Replacing the tank
cartridge:
Unscrew the tank cartridge connection from the empty tank cartridge.
Loosen the securing belt on the tank cartridge.
Remove empty tank cartridge from the tank cartridge holder.
After use, firmly close the cap of the tank cartridge.
Insert a new, sealed original tank cartridge into the tank cartridge holder.
Secure the tank cartridge with the securing belt.
Open cap and keep safe.
X Observe the safety instructions for methanol.
Zobrazit stránku 116
1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 261 262

Komentáře k této Příručce

Žádné komentáře